STE-34

IN A HIGH CONCENTRATION, THIS MATERIAL IS POISONOUS.

THE EXTERNAL DIAMETER MUST BE CONCENTRIC TO THE INTERNAL DIAMETER.

THIS PROCEDURE IS APPLICABLE ONLY TO A TYPE B UNIT.

AT THE END OF THE TEST, SET THE SWITCH TO“NORMAL”.

IF THE RESULTS OF THE TEST ARE UNSATISFACTORY, REPLACE THE UNIT.

DO THESE TWO PROCEDURES AT THE SAME TIME.

SET THE SWITCH TO THE“ON”POSITION TO REMOVE THE CONDENSATION.

THESE INITIAL CONDITIONS ARE NECESSARY TO GET CORRECT RESULTS.

DO A CHECK OF THE UNIT CONDITION.

DO THE LEAK TEST.

IF THE DAMAGE IS ONLY TO THE MIDDLE TREADS, THE TIRE IS SERVICEABLE.

IF POSSIBLE, DO AN ENGINE GROUND RUN TO MAKE SURE THAT YOU GET THE SAME INDICATIONS.